<![CDATA[Isadora to arduino]]>Hello,

Working with a friend and he has been helping me set up my arduino to talk to Isadora. There is a problem in arduino 1.0.5 as the BYTE keyword is no longer supported and I am wondering what would go in its place. In the following sketch, I am trying to activate a movie by pressing a button that is connected to digital pin 2\. I see the state change in the Arduino serial window, but when I change over to Isadora, after setting up serial communication, nothing changes.
This is the arduino sketch before I institute the change from   Serial.print(i+97,BYTE); //send the port number to the arduino suggested Serial.write(). I am unclear as to what should be contained within the parentheses following the Serial.write call. Any Suggestions? I currently have Serial.write(13); and I am getting clean serial output to the arduino serial window, but again, when I switch over to Isadora and take initiate serial I do not get any response. I have included the arduino sketch in the body and the izzy patchas an attachment.
 Thank you,
Michael
/*
This should enable you to read all the arduino pins in Isadora.
Edit the ones you don't need out of this script.
*/
int delval=100; //set this to adjust the polling value
int value;
int anports=5; //no of analog ports to read - note 0 means you will read one port. To skip reading any ports comment out the lop below
int digports=13; //as above but with digital ports
void setup()
{
  Serial.begin(9600); //you can change the baud rate
}
void loop()
//comment out this loop to avoid reading any analog ports
{
  for (int i=0; i<=anports; i++)  {
  value = 1000+analogRead(i); // add 1000 to the value of the pin to ensure 4 digits.
  Serial.print(i,DEC); //send the port number
  Serial.print(value); //send the value
  Serial.println(); //send the eom
   
  }
  //comment out this loop to avoid reading any digital ports
    for (int i=0; i<=digports; i++)  {
  value = digitalRead(i); // add 1000 to the value of the pin to ensure 4 digits.
  Serial.print(i+97,BYTE); //send the port number
  Serial.print(value); //send the value
  Serial.println(); //send the eom
    }

27d2ca-arduinotoisadora.izz

]]>https://community.troikatronix.com/topic/1806/isadora-to-arduinoRSS for NodeMon, 05 Oct 2026 15:33:06 GMTWed, 04 Mar 2015 14:20:23 GMT60<![CDATA[Reply to Isadora to arduino on Wed, 04 Mar 2015 14:30:23 GMT]]>Dear All,

Figured it out, just had to eliminate the BYTE and enter the remaning i+97 into the parentheses
]]>https://community.troikatronix.com/post/14840https://community.troikatronix.com/post/14840Wed, 04 Mar 2015 14:30:23 GMT