Connecting with projectors
-
Dear Community,
Yesterday I had issues where an Optoma projector was not recognized by my Matrox TH (DP edition). I had a backup with a Windows laptop, so there everything worked fine.
This scenario happens so often that projector is not recognized by the machine. Is there a list you go through while troubleshooting?
I just want to be sure I tried everything before I give up and move on to plan B or plan C.
Alexander Nantschev | http://www.crystalhorizon.at | located in Vienna Austria
-
My experience has been that it's usually a Matrox setup issue.. and not an issue with the projector.
No specific steps really though.
-
Alex - does your Optoma have a RESYNC button on the remote - that could be a possible starting point when troubleshooting projection issues with Optomas.
i hate Matrox software. if you have different brand/length of signal cables going to each projector, sometimes things go wonky in Powerdesk and you end up with a bunch of question marks where you should have happy monitors.
John
-
I don´t have anymore access to that specific Optoma, but good to know about the RESYNC on the remote. I have another one at my disposal, so next time I run into the a similar problem, I will definitely try that one.
Yes the Matrox software can create a bunch of question marks
