Blending Two Projectors

[DusX]

@jamie-nesbitt

Do you mean edge blend?
If so the Stage Setup (Output->Stage Setup).
A new tool for this was shown at this years Werkstatt this summer. I think it was part of the Keynote.
Not sure if the video has been posted yet.

[Jamie Nesbitt]

@dusx said:

Werkstatt

 I see the 2016 but don't see the 2017. Cheers.

j

[Jamie Nesbitt]

@dusx If I want play one movie.  Should I split that one movie into two streams? Each going into their respective panner actor, then each goes into their respective projector actor?

[bonemap]

@jamie-nesbitt said:

panner actor,

@DusX  reminded me not so long ago about the Chopper actor that is specifically for this purpose. Then use Projector actors and the Stage Set-Up interface to blend the outputs.

Regards

Bonemap 

[DusX]

@jamie-nesbitt

I guess it's not online. 

Quickly, there is a new Stage Setup feature coming after 2.6. It's like an Izzy Map for stage setup, and will allow endless options for outputs / blending etc... 

[Jamie Nesbitt]

@dusx Cool! Any idea when that's coming out?

[DusX]

@jamie-nesbitt

We can't give a timeline yet, other than to say after 2.6

[bonemap]

@dusx said:

A new tool for this was shown at this years Werkstatt this summer. I think it was part of the Keynote.Not sure if the video has been posted yet.

Hi,

I would be interested to see/access a recording of the Keynote presentation from 2017. It wasn’t streamed as far as I know, but it would be great to see it.

Best wishes

Bonemap 

[Jamie Nesbitt]

In Stage Output, is the width number a percentage? So I'm doing a 15% blend should the width right/left have a value of 15 as well?

[DusX]

@jamie-nesbitt

yes the width is a percent, as well as edge blend position etc.