OSC Transmit - To iPad
-
Hi everyone.
This isn't exactly an izzy issue - however I am hoping someone with some Hexler.net experience can offer some setup insight.I have been playing with TouchOSC and getting izzy to work with commands from my ipad successfully.
However, I am trying to turn on an led on the ipad once a horizontal fader (on the same OSC page) hits 100.I have the OSC transmitter:
- 10.0.7.1 = udp addr
- 1234 = port
- /led 1 = osc address
- off = use type
- 100 = value
Image attached.
My assumption is, when the fader hits 100, the led should turn on.Not so (yet).
Any one offer some insight?
Thanks kindly.
-
Port 1234 is the isadora port. Touchosc will have it's own port for incoming data. I think by default it's 5001.
-
Brilliant! Reset to the ipad incoming port 9000 Thanks much.
-
So is it working now?
it's often handy to have the touchOSC editor open so you can copy and paste all the pathways; _"/1/fader/"_, etc.I keep meaning to make a tutorial about this actually.... -
Works great!
Thanks again. -
prods Skulpture keep meaning to a bit quicker nod nod
;) -
Haha ok. It's only difficult to do as I can't screen capture it all in one go, I need to film my iPad, etc. I will try an do it this week for you.
-
This should help @marci
http://www.youtube.com/watch?v=UlW2H7SVou8 -
@Chizzer basically OSC is from 0.0 to 1.0 so its not when it triggers 100 but 1.
-
Part 2; for @Marci
http://www.youtube.com/watch?v=MCDZEJc2x5E -
Cheers fella... much appreciated!
