Receive DMX IN from a lighting board to ENTTEC controllers
-
Hi,
I have some problemes with DMX USB Pro ENTTEC. Here is what i want to do.
I want to connect connect a lighting board to a "DMX ENTTEC controller" to receive DMX data from the lighting board.
I have found somes patches on differents forum.With theses patch, I'm able to send DMX to the lights but I receive no "DMX IN" from the lighting board.
When I close Isadora, it's work but, in the moment when I open the application, I don't receive information from DMX IN
Does someone have a solution
Thank you very much.
(sorry for my bad english)
P.S I have join a image to show what I want to do
Gaspard
-
Hi @gaspardphilippe,
Could you please share your Izzy file, if the forum doesn't accept the format then just zip it :)
-
try entering:
{{ 7E 05 }}
5?
chan_1 : integer = ?
chan_2 : integer = ?
chan_3 : integer = ?
chan_4 : integer = ?into the Edit Serial Input Parser, of a Serial In Watcher (text)
The EOM I am unsure. but if you have a data stream you can prpbably just adjust this input until you have the data correctly.
-
-
@dusx said:
{{ 7E 05 }}5?chan_1 : integer = ?chan_2 : integer = ?chan_3 : integer = ?chan_4 : integer = ?
Hi Dusk thank you for your help:
I have made what you tell me to do but when I change the EOM char input, i have this message:
The input buffer for the "serial in watcher" is full, Accumulated data has been discarded
In fact, I don't understand what I'm supposing to enter in the EOM char and what is the signification of this.
Do you think, it is the lenght of the message ?
Gaspard
-
It is the 'End Of Message' delimiter. So it's the character at the end of the dmx message.
-
It should match the 'postfix' from the Matrix Value Receive (so that the formats are the same).
It is 'E7' or '231' as decimal.
