[TICKET SUBMITTED] Enttec DMX USB pro on Isadora 3
I was wondering if Enttec DMX USB pro was working on Isadora 3, so i found on this page of the forum
this patch: https://community.troikatronix...
but i had to install drivers to make it recognize by serial port i used this https://www.enttec.co.uk/en/pr...
And it works tested on isadora 3,
driver wasn't requiered sorry...
Hi @mark i had a few pb with matrix value send, sometimes actor freezes and can't use mouse to set value, nore move the actor...
i'll try to reproduice the beug tomorrow, but it did happen a few times on 2 mbp on mojave...
dbini last edited by
I can confirm that my Enttec patch works fine in Izzy2 but nothing happens with the same setup in Izzy3.
thanks for your input @dbini yesterday was working more or less... today nothing with same config on isa 3... a bit lost...
device is working on maxmsp but nothing in isadora... i'll go make my bridge and submitt a ticket;)
I did a maxruntime to drive the Enttec, and an isa patch to recieve osc 0-100 from a controlleur, and send it to max, just an emergency system to wait for the bug to be corrected, if you have any suggestion for transitions from one scene to another could be great, thanksusbdmxmaxisa
mark last edited by
@DusX replied to your bug report, asking you to set the 'min period' input to 25mS or greater. Did you do that?
That said, I am away from the TroikaTronix HQ for two weeks, and the Enttec I use for testing is there.
Dear @mark, yes i recieved a ticket from Ryan @DusX , to whom i'll copy this post,
i agree with the overload, so i put the flood down with a pulse but the problem remains...
I guess it comes more from the Enttec interfacing or the matrix user actor, thanks.enttec-user-actor-demo-v3-benedit.izz.zip