Instant volume change in movie player
-
sorry, i forgot wo write that is doesnt help. Still the gap in the audio when looping. And still the delay when turning on/off audio volume.
-
Hmm, another way i use is the envelope generator. Works perfectly as well. But maybe you find a windows person.
-
Both Hap and pjpg use QuickTime for playback, therefore the audio also uses it.Perhaps recompressing to a Directshow codec will help in that the audio will pay via a new engine.If you continue to have problems, please open a support ticket (link in my signature) and I will do my best to help you find a solution. -
actually i never worked with dirct show codes. Which ones are good for widows?
-
WMV as a container usually has h264 defaults from editing software (premiere, Ae, etc..)
AVI, can contain many things. Using Cinepak will give performance similar to a pjpeg mov (my experience)You can see a break down of what is supported by DirectShow here: https://msdn.microsoft.com/en-us/library/windows/desktop/dd407173%28v=vs.85%29.aspx?f=255&MSPPError=-2147217396Its important to note, that currently .mp4 as well as the sound formats are handled by Quicktime in Isadora. -
Hey Ryan,
thanks for your advice. I used avi with the Intel IYUV codec (because i dont have the cinepak codec) and sound is instantly there. Perect!Niklas
-
I just made some more Tests and converted my new videos with mpeg streamclip into "apple cinepak". But unfortunalty the quality is not good, even on 100%. So I will try mp4, or did you have any bad experience with that?
-
I (almost) ended in unsing apple component video YUV which gives the volumecontrole an instant reaction and the compression looks good on the image. But now I have some jerk (I hope thsi is the right word). Its just not playing perfectly smooth, although the framerate is constantly at 25fps. And since I have very slow camerapans in my video this is very important. Any idea what could work better.
-
There is a Knowledge Base article about the best way for windows to go: http://troikatronix.com/support/kb/optimizing-for-speed/**excerpt**: _When running Windows, we recommend using AVI or WMV formats, because these movies will use native Windows routines for playback, as opposed to .mov files which require Apple’s QuickTime. _Michel -
-
so finally avi worked good for me for instanz volume change of a video. But no I want to change the volume of a soundplayer instantly from 0 to 100 and back as well as do slight volumefades. When changing I hear always some short "audio cracks". Is there any chance to change the volme clean?
-
Open Quicktime Player, and check its audio setup in preferences.You likely have a few options there. Depending on your system's audio card, one may be better than the others.I am using 'Windows Audio Session' and haven't had problems, but you may do better with 'Direct Sound', or 'Safe Mode'. -
@DusX
I tried all 3 settings, but all had cracks in the sound. -
What is the audio card you are using?
-
Also, if going instantly from 0 to 100 you might always get a crack..
You may be better to use a short (1/4 second) fade.. -
Its the onboard audiocard. coulndt find more than "realtek high definition audio".
-
Sure I have a realtek as well.
Have you tried with the ultra short fade? -
yes, I tried the short transition but still the same. And anyway I also need the smooth transitions. By the way I used wav-files.
I now tried an mp3-file which is played only in the movieplayer, not in the sound-player. But this seems to works fine now for me.
