Patch keeps developing a problem after a few hours use
one of the isadora patches in use –for a camera being shown on all 3 stages of a triplehead to go– has been dropping the signal from either stage 1 or stage 2 or stage 3 after a certain number of hours of use, or upon start-up.
that is to say;
in the patch all 3 stages show the live camera.
sometimes –after a few hours or upon startup– one stage is dark and not showing signal.
the empty stage can be either stage 1 or 2, not usually 3. but one time both stage 2 and 3 were not showing signal.
so far, duplicating the patch with a different name always solves the issue temporarily.
the issue reappears after 3 or more hours, or after the next machine startup.
the usual troubleshooting steps have taken place, and everything works for a while, but eventually the same problem occurs again.
--has anyone else had this problem?
2014 MBP, yosemite 10.10.4 , 2.8, 16 gigs Ram, 1T flash hard drive/Isadora 2.0.5
Please feel free to submit a bug report here: http://troikatronix.com/support/isadora/and one of use will happily try to solve the issue with you.
mark last edited by
thanks mark + ryan, bug report sent in